Creston Connected - Kimex 164-5521 Manuel D'utilisation

Creston Connected

- In order to work with Crestron Connected protocol, "CrestronConnected" profile option should be enabled.
- Flash UI which is served by the display device is not supported. Flash UI which is served by the control
system can be used. Flash UI will not be directly connected to display device but will be connected indirectly
over control system in this case.
- Widi source is not visible to the Crestron Connected interfaces (e.g. Roomview, Xpanel). The reason is when
we select this source the connection is broken and therefore could not communicate with crestron devices again.
- Configuration page to set control system ip address/hostname, ip id, and port can be reached by writing the
ip address of display to the browser address bar on your computer.
- If SecureCommand profile option is enabled, configuration page is opened with a password dialog. After
entering the correct password configuration dialog appears. Password is the same with the one used in
SETUSERSECLEVEL command.
English - 42 -