Set The Cutting Height; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks MO48L520 Manuel D'utilisation

EN
3. Close the side discharge door.
7.7

SET THE CUTTING HEIGHT

The machine can be set to different cutting heights.
1. Pull the height adjustment lever (6) rearward to increase
the cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
7.8

INSTALL THE BATTERY PACK

THIS MOWER MUST HAVE TWO BATTERIES TO RUN!
17
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
Optimize the power and performance of your new 2x24
mower by running with both batteries charged to 100%.
7
18
WARNING
NOTE
English
1. Open the battery door (7).
2. Align the lift ribs on the battery pack (17) with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery door.
The motor starts only when you put in the safety key (19).
6
7.9

REMOVE THE BATTERY PACK

1. Open the battery door (7).
2. Remove the safety key (19).
3. Push and hold the battery release button (18).
4. Remove the battery pack from the machine.
8

OPERATION

Wear eye protection during operation.
8.1

START THE MACHINE

19
1. Make sure safety key is inserted into slot.
2. Push and hold the start button (1).
3. While you hold the start button (1), grab the start handle
(2) in the direction of the handle bar.
4. Once the machine has started, you can release the start
button.
5. Press Turbo button to speed up to 3,250 RPM
10
NOTE
WARNING
1
21
11
2
TURBO