Install The Mulch Plug; Set The Blade/Cutting Height; Install The Battery Pack; Remove The Battery Pack - GreenWorks G24X2LM36 Manuel Opérateur

1. Remove the mulch plug.
2. Open the rear discharge flap and hold it.
3. Hold the the grass catcher by its handle and put the hooks
over the slots.
4. Close the rear discharge flap.
6.5

INSTALL THE MULCH PLUG

Figure 4.
1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge flap.
6.6 SET THE BLADE/CUTTING
HEIGHT
The machine can be set to different blade/cutting heights.
Figure 5
1. Pull the height adjustment lever forward to increase the
blade/cutting height.
2. Pull the height adjustment lever rearward to decrease the
blade/cutting height.
6.7

INSTALL THE BATTERY PACK

Figure 6
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
WARNING
USE ONLY 24V BATTERY. DO NOT USE DUAL-
VOLTAGE 24/48V BATTERY.
Both batteries should be installed into the compartments in
order to start the machine.
1. Open the battery flap.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery flap.
NOTE
English
The motor starts only when you put in the safety key.
6.8

REMOVE THE BATTERY PACK

Figure 6
1. Open the battery compartment flap
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
7

OPERATION

Wear eye protection during operation.
7.1

START THE MACHINE

Figure 7
Install the grass catcher before mowing.
1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the handle switch in
the direction of the handle bar.
4. Release the start button to start the machine.
7.2

STOP THE MACHINE

Figure 7
1. Release the handle switch to stop the machine.
Wait until the blade fully stops before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
7.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge flap.
7. Empty the grass catcher.
9
NOTE
WARNING
NOTE
WARNING
WARNING
EN