Install The Side Discharge Chute; Set The Blade Height; Install The Battery Pack; Remove The Battery Pack - GreenWorks LMB401 Manuel De L'opérateur

EN
7.6 INSTALL THE SIDE DISCHARGE
CHUTE
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge door (6) and hold it.
2. Line up the recesses of the side discharge chute (7)
below the pivot.
3. Close the side discharge door.
7.7

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
1. Pull the height adjustment lever (8) rearward to
increase the blade height.
2. Pull the height adjustment lever forward to decrease
the blade height.
6
7
CAUTION
8
English
7.8

INSTALL THE BATTERY PACK

17
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Open the battery door (5).
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack (17) into the battery
compartment until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The motor starts only when you put in the safety key
(19).
7.9

REMOVE THE BATTERY PACK

1. Open the battery door (5).
2. Remove the safety key (19).
3. Push and hold the battery release button (16).
4. Remove the battery pack (17) from the machine.
8

OPERATION

Wear eye protection during operation.
10
5
18
19
WARNING
NOTE
WARNING