Makita LS1017 Manuel D'instruction page 15

Position the vise arm according to the thickness and
shape of the workpiece and secure the vise arm by
tightening the screw. If the screw to secure the vise arm
contacts the guide fence, install the screw on the oppo-
site side of vise arm. Make sure that no part of the tool
contacts the vise when lowering the handle fully and
pulling or pushing the carriage all the way. If some part
contacts the vise, re-position the vise.
Press the workpiece flat against the guide fence and the
turn base. Position the workpiece at the desired cutting
position and secure it firmly by tightening the vise knob.
WARNING:
• The workpiece must be secured firmly
against the turn base and guide fence with
the vise during all operations. If the workpiece
is not properly secured against the fence the
material may move during the cutting operation
causing possible damage to the blade, causing
the material to be thrown and loss of control
resulting in serious personal injury.
Horizontal vise (optional accessory)
1
2
► 1 . Vise plate 2. Vise nut 3. Vise knob
The horizontal vise can be installed in two positions on
either the left or right side of the base. When performing 10°
or greater miter cuts, install the horizontal vise on the side
opposite the direction in which the turn base is to be turned.
By flipping the vise nut counterclockwise, the vise is
released, and rapidly moves in and out. To grip the work-
piece, push the vise knob forward until the vise plate con-
tacts the workpiece and flip the vise nut clockwise. Then
turn the vise knob clockwise to secure the workpiece.
The maximum width of workpiece which can be secured
by the horizontal vise is 215 mm (8-1/2").
WARNING:
• Always rotate the vise nut clockwise until
the workpiece is properly secured. If the
workpiece is not properly secured the material
may move during the cutting operation causing
possible damage to the blade, causing the
material to be thrown and loss of control result-
ing in serious personal injury.
• When cutting a thin workpiece, such as base
boards, against the fence, always use the hori-
zontal vise.
OPERATION
NOTICE:
• Before use, be sure to release the handle from the
lowered position by pulling the stopper pin.
• Do not apply excessive pressure on the handle
when cutting. Too much force may result in over-
load of the motor and/or decreased cutting effi-
ciency. Push down handle with only as much force
as is necessary for smooth cutting and without
significant decrease in blade speed.
• Gently press down the handle to perform the cut. If
the handle is pressed down with force or if lateral
force is applied, the blade will vibrate and leave a
mark (saw mark) in the workpiece and the preci-
sion of the cut will be impaired.
• During a slide cut, gently push the carriage toward
the guide fence without stopping. If the carriage
movement is stopped during the cut, a mark will
be left in the workpiece and the precision of the
cut will be impaired.
3
WARNING:
• Make sure the blade is not contacting the
workpiece, etc. before the switch is turned
on.
Turning the tool on with the blade in contact with
the workpiece may result in kickback and seri-
ous personal injury.
15 ENGLISH