Makita LS1017 Manuel D'instruction page 13

1
► 1 . Blade case 2. Arrow 3. Arrow 4. Saw blade
1 2
► 1 . Hex bolt 2. Outer flange 3. Saw blade 4. Inner
flange 5. Spindle
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the sur-
face of the blade matches the direction of the arrow on
the blade case.
Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed)
securely counterclockwise while pressing the shaft lock.
1
► 1 . Socket wrench 2. Blade case 3. Center cover
4. Hex bolt 5. Blade guard
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Release the handle from the raised
position by pulling the stopper pin. Lower the handle to
make sure that the blade guard moves properly. Make
sure the shaft lock has released spindle before making
cut.
2
3
4
4 5
3
2
3
5
4
13 ENGLISH
Connecting a vacuum cleaner
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner.
Dust bag
2
3
► 1 . Dust nozzle 2. Dust bag 3. Fastener
The use of the dust bag makes cutting operations
cleaner and dust collection easier. To attach the dust
bag, fit it onto the dust nozzle.
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty
the dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might
hamper further collection.
1