Aux Operations - Clarion M608 Mode D'emploi Et Manuel D'installation

Bluetooth Operations
about tracks (e.g. the elapsed playtime, song
title, etc.) cannot be displayed on this unit.
When an A2DP device is disconnected, "NO
DEVICE" will be shown on the display and
the unit will return to previously selected
audio source. Some Bluetooth audio players
may not have play/pause synchronized with
this unit. Please make sure both device and
main unit are in the same play/pause status
in BT MUSIC mode.
ID3 Display
During music streaming playback, for music
information that is longer than the display
panel:
When SCROLL is ON, the LCD will display
ID3 TAG information, e.g:
ALBUM -> TITLE -> ARTIST..

AUX Operations

The rear RCA AUX terminals of this system is
provided to allow playback of sounds and music
from external devices connected to this unit.
Press [ / SRC] button on the panel to select
"AUX 1" or "AUX 2".
AUX Input Sensitivity Setting
Select the following settings to set the sensitivity
level of the sound from an external device con-
nected to this system, that are difficult to hear,
even after adjusting the volume.
* The factory default setting is "MID".
1. Long press the [MENU] button.
2. Press the [ ] button until "AUX SENSE"
appears in the display.
3. Rotate the [UP/DOWN] knob to select "HIGH",
"MID" or "LOW".
Note:
• W hen AUX mode is selected, AUX IN sensi-
tivity can be set.
When SCROLL is OFF, the LCD will display
one of the ID3 TAG information, the default
is TRACK, but user can adjust it to other
ID3 TAG information by pressing the [ENT]
button.
MTP Operations
Media Transfer Protocol (MTP) allows the M608
to connect and play media from your Android
device.
1. Open the MTP function of your Android
device. This is generally found in the USB
settings section.
2. Connect the Android device to the M608 via
a USB cable.
3. The unit will play the media on your Android
device automatically.
13
M608