Clarion M608 Mode D'emploi Et Manuel D'installation page 20

8) Wiring and Connections
Tower mode connections
Radio Antenna
Left
(White)
Right
(Red)
Left
(White)
Right
(Red)
Left
(White)
Right
8-Channels
(Red)
of Amplification
Left
(White)
Right
(Red)
SiriusXM Connect
Tuner
(sold separately)
Steering Wheel Remote Control Terminal
Connect
to external
wired Remote
Control Unit
(sold separately)
Left(White)
Right(Red)
Left(White)
Right(Red)
Connect to USB memory/
iPod/iPad/iPhone device
Refer to the right
Front
Gray
Rear
Black
Non-Fade/Sub
Purple
Tower
Green
SiriusXM
Black
SWC
Black
Wired Remotes
Black
AUX IN 1
Black
AUX IN 2
Grey
USB cable
Black
Gray
Right
Gray/Black
Front
White
Left
White/Black
Purple
Right
Purple/Black
Rear
Green
Left
Green/Black
4-Speaker system
or
2-Speaker system
Gray
Right
Gray/Black
Front
White
Left
White/Black
Purple
Purple/Black
Not used.
Insulate
Green
each wire
Green/Black
9) Connecting to External Amplifiers
• Connecting to External Amplifiers
External amplifiers can be connected to the 4 channel RCA output connections.
Ensure that the connectors are not grounded or shorted to prevent damage to the unit.
• If M608 is connected as a TOWER configuration with Fixed/Zone4 RCAs connected to
an amplifier, do not switch M608 to STANDARD mode. Doing so will cause Fixed/Zone4
amplifier to reproduct a full range of frequencies at maximum volume. This may result in
potential speaker and/or hearing damage.
• If M608 is connected as a TOWER configuration with Fixed/Zone4 RCAs connected to
an amplifier, do not switch M608 to STANDARD mode. Doing so will cause Fixed/Zone4
amplifier to reproduct a full range of frequencies at maximum volume. This may result in
potential speaker and/or hearing damage.
16-Pin Connector Extension Lead
(attached to the source unit)
Yellow wire (Memory back-up lead)
Connect directly to battery
FUSE 15A
Red wire (Power lead)
Accessory 12V
Blue/White wire (Amplifier turn-on lead)
Connect to remote turn-on lead on the amplifier
Blue wire (Auto ANT lead)
Connect to Auto antenna
Black wire (Ground lead)
Connect to ground
Orange/White wire (Illumination lead)
Connect to the illumination circuit on the
boat
19
M608