Connection With The Mains; Operation; Operation Via Dip Switches - EuroLite LED T-36 Mode D'emploi

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

The device has two operating modes. It can be operated via DIP Switches or it can be run in DMX-controlled
mode.
After you connected the spot to the mains, the EUROLITE LED T-36 RGB Spot starts running.

OPERATION VIA DIP SWITCHES

International
L
N
18/40 00024228.DOC, Version 1.2