LOCaTION reQUIreMeNTs
Proper installation is your responsibility.
You will need:
A water heater set to 120° F (49° C).
n
A grounded electrical outlet located within 6 ft (1.8 m) of
n
power cord on back of washer.
Hot and cold water faucets located within 4 ft (1.2 m) of hot
n
and cold water fill valves on washer, and water pressure of
20-100 psi (137.9-689.6 kPa).
A level floor with maximum slope of 1" (25 mm) under entire
n
washer. Installing on carpet or surfaces with foam backing is
not recommended.
Floor must support washer's total weight (with water and load)
n
of 315 lbs (143 kgs).
IMPORTANT: Do not install, store or operate washer where
it will be exposed to weather or in temperatures below 32° F
(0° C). Water remaining in washer after use may cause damage
in low temperatures. See "Washer Care" in Washer Use and Care
Guide for winterizing information.
All dimensions show recommended spacing allowed, except for
closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of
installation and servicing, and spacing for companion appliances
and clearances for walls, doors, and floor moldings.
Space must be large enough to allow door to fully open.
Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or louvered door is installed, top
and bottom air openings in door are required.
Recessed area or closet installation
(stacked washer and dryer):
5"
(127 mm)
1"
(25 mm)
Custom under counter installation:
1"
(25 mm)
6"
(152 mm)
3"
(76 mm)
48 in.
(310 cm
/
77
"
1
2
(1969 mm)
24 in.
(155 cm
3"
(76 mm)
1"
(25 mm)
39" min.
(990 mm)
1"
(25 mm)
51"
(1295 mm)
Recessed area or closet installation (washer only):
2
4"
)
2
(102 mm)
2
)
2
Custom cabinet installation:
(102 mm)
27"
(686 mm)
38"
(965 mm)
(13 mm - 25 mm)
31
/
"
1
2
(800 mm)
3"
(76 mm)
3"
(76 mm)
1"
(25 mm)
1"
(25 mm)
7"
(178 mm)
14"
(356 mm)
4"
1"
(25 mm)
/
" - 1"
1
2
48 in.
2
(310 cm
)
2
24 in.
2
(155 cm
)
2
1"
(25 mm)
3