Care And Maintenance; Maintenance - TerraTec T.RJP.80M Manuel D'utilisation

800mm babyleaf harvester
Instruction manual

CARE AND MAINTENANCE

Do not modify the harvester's structure, install another type of motor or fit tyres of a different size or type from the original tyres.
Any failure or malfunction of the machine due to an unauthorised modification is not covered by the warranty. Furthermore,
Terrateck shall not be held liable for any consequences.
The machine is designed and manufactured according to our strict quality charter. However, if you should notice any defects,
please notify our agents before operation.
Never mount unauthorised equipment to the machine or make unauthorised modifications.
!
During the care or maintenance phases, make sure no one is located
near to the machine.
IMPORTANT

MAINTENANCE

(51) When preparing to maintain the harvester, place the machine on a hard and level surface.
(52) Block the wheels with chocks.
(53) The work area must be adequately lit to prevent accidents.
!
Remove the combi-drill from the harvester.
IMPORTANT
(54) Before removing a safety device, such as a protective cover, make sure that the combi-drill has been removed from the
machine.
!
Do not forget to put the removed safety covers back on because the uncovered hazardous parts can cause
serious injuries.
IMPORTANT
42 www.terrateck.com
800mm babyleaf harvester
Instruction manual
(55) Check the safety pictograms stuck to the machine. These help you to identify hazardous points and point out the risks in-
curred at each of these points.
!
It is important to make sure that these pictograms stay in place and are legible by the user.
IMPORTANT
Here are some guidelines for their maintenance:
(56) Do not cover the pictograms, so that they remain visible at all times. If they are dirty, clean them with soapy water and dry
them with a soft cloth. If they come unstuck or get damaged or torn, order a new safety sticker from your Terrateck agent. Place
the new sticker where the old one was located in accordance with the diagram below. When sticking a new sticker, first clean
the area with soapy water, rinse thoroughly and dry the surface to be glued. When glueing, eliminate any air bubbles that may
affect the glueing process resulting in a poor bond.
The references of the safety pictograms and their location on the machine are provided here.
(57) Each time the machine is used, clean the cutter bar with a high-pressure water jet to remove any sap or other organic matter that
can damage the materials and, hence, the effectiveness of the blades.
(58) Immediately after each use, lubricate the cutterbar with a fine oil recommended by Terrateck (T.RJP.H1000)
(59) Replace the cutter guard.
www.terrateck.com
ATTENTION LAMES
BLADES CARE
RISQUE DE COUPURE
RISK OF CUTS
DANGER
43