Perel CFANAM5RM Mode D'emploi page 5

5. Overview
Refer to the illustrations on page 2 of this manual.
1
2
6. Operation
1. Install the fan on a dry, level and non-slippery surface.
2. Connect the fan to the mains.
3. Press the on-off switch to switch on the fan. Set the timer and fan speed with the
timer and speed buttons. You can also control the fan using the included remote
control.
4. Switch off the fan and disconnect from the mains after use.
7. Wall-Mounting
1. Locate and mark the position on the wall where the fan will be mounted.
2. Measure and drill the mounting holes according to the base of the fan.
3. Insert an appropriate nylon plug and screw into each hole (plugs and screws not
included). Leave approximately 1.5 cm of the screw exposed.
4. Hang the fan on the wall.
8. Cleaning and Maintenance
Before starting any cleaning activities:
1. Switch off the device.
2. Unplug the device's power cord from the outlet.
Cleaning
1. Switch off the appliance.
2. Unplug the appliance from the mains.
3. Clean the inlet and outlet ribs with a vacuum cleaner.
Do not disassemble the appliance.
Do not immerse the appliance in water or any other liquid. Do not clean the appliance
with water and never allow water to enter the motor and housing.
Do not use harsh chemicals, cleaning solvents or strong detergents.
Storing
Store the device in its original package in a dry and clean place.
RED Declaration of Conformity
Hereby, Velleman NV declares that the radio equipment type [CFANAM5RM] is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address: www.velleman.eu.
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulting from (incorrect) use of
this device. For more info concerning this product and the latest version of this
V. 01 – 16/08/2018
speed button
on-off button
CFANAM5RM
3
5
timer button
©Velleman nv