Dimmer; Changing The Input Source - Esoteric K-01XD Mode D'emploi

Dimmer

You can adjust the brightness of the main unit's display.
DIMMER 3
c
(normal brightness)
DIMMER 2
c
DIMMER 1
c
(off )
o Even when the dimmer is off, the display will light at normal bright-
ness for about three seconds when you press the play/pause
(y/9) or another button.
o Even when set to DIMMER 1 or off, setting menus and error mes-
sages will be shown with normal brightness (DIMMER 2).

Changing the input source

When stopped, press the MODE button repeatedly to cycle through
the following input sources.
CD/SACD
USB in
(USB input
for computer)
o This unit can be used as a D/A converter when its input source is
set to an external digital input (RCA in, OPT in or USB in).
o When an external digital input is selected, the name and sampling
frequency of the selected input appear on the display. If there is no
input signal or the unit is not synchronized to the input signal, the
input sampling frequency is not shown and the input name blinks.
o If the input signal is not a digital audio signal or uses an audio signal
format that is not supported by this unit (such as Dolby Digital, DTS
or AAC) "- - -" appears in place of the sampling frequency. Set the
digital output of the connected equipment to PCM audio output.
o When an external digital input is selected, disc controls other than
the tray open/close (-) button do not function.
RCA in
(coaxial
digital input)
OPT in
(optical
digital input)
21