Setting Mode - Esoteric K-01XD Mode D'emploi

Setting mode

The settings for this unit are divided into two groups: Settings 1 and
Settings 2.
The Settings 1 or Settings 2 group will be shown depending on how
the MODE button is pressed.
1
2
Changing settings
1
When stopped or during playback, press the
MODE button for at least two seconds.
Press for at least
2 seconds
Settings 1 will be shown.
To show Settings 2, press the MODE button again for at least two
seconds while Settings 1 is shown.
2
Press the MODE button repeatedly to select the
item to change.
Each time you press the MODE button, the item shown on the
display changes as follows.
24
4 3
3
4
Settings 1 Settings 2
UPC> PCMM>
c
CLK> PCMG>
c
AOUT> DSDF>
c
DOUT> RS232C>
c
DPaOFF> AUD_UPDATE
c
APS>
o Depending on the selected source and operation status,
some items might not appear.
o If you do nothing for ten or more seconds, setting mode will
end and ordinary display will resume.
However, setting mode will not end when Settings 2 AUD_
UPDATE is in use.
Use the skip (.//) buttons to change
settings.
To change multiple items, repeat steps
Press the Stop (8) button.
Setting mode will end and the ordinary display will reappear.
o Setting mode will also end and the ordinary display will reap-
pear if nothing is done for ten seconds. However, setting
mode will not end when Settings 2 AUD_UPDATE is in use.
o Settings are retained even if the power plug is disconnected.
c
c
c
c
2 3
and .