Touch control
Noted:
1.Before using the remote control, please Remove the battery
film!3V CR2032 battery included.
2.Please abandon old batteries at battery collection points
STANDBY MODE
After plug in, only
"ON/OFF" Button:
In STANDBY MODE press
The buttons and the display panel will light. The hood
is ready to operate. By default, the hood is set to the
minimum suction, lighting off. This is also valid when
using the remote control.
When you turn the hood back on after first use, it will
operate with the same settings previously used.
When the hood is in operation, when you press once, the
suction will be stopped and the lighting will remain active.
If you press and hold for 3 seconds, the hood will be in
standby mode: suction, lights off and the window will
close.
flashing slowly, system in STANDBY MODE.
the window will open.
51
Remote control