Danby DPA120CB1WDB Guide D'utilisation Et D'entretien page 16

Installation Instructions
WATER DRAINAGE
Fig.20
Remove the
upper drain
plug
Fig.21
During dehumidifying modes, remove the upper drain plug from
the back of the unit, install the drain connector (5/8" universal
female connecter) with 3/4" hose (not included). For the models
without a drain connector, just attach the drain hose to the hole.
Place the open end of the hose directly over the drain area in
Continuous
drain hose
your basement fl oor. Please refer to Fig. 20.
NOTE: Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that there are no
kinks that will stop the water from fl owing. Place the end of the
hose into the drain and make sure the end of the hose is down to
let the water fl ow smoothly. (see Fig. 21). Never raise it. (See Fig
22, 23).
• When the water level of the bottom tray reaches a predeter-
mined level, the unit beeps 8 times, the digital display area
shows P1. At this time the air conditioning/dehumidifi cation pro-
cess will immediately stop/ However, the fan motor will continue
to operate (this is normal). Carefully move the unit to a drain
location, remove the bottom drain plug and let the water drain
away (Fig. 23). Restart the machine until the P1 symbol disap-
pears. If the error repeats, call for service.
NOTE: When operating or draining water, always protect carpet-
ing or fl oors from possible water spillage.
NOTE: Be sure to reinstall the bottom drain plug before using
the unit.
Fig.22
Fig.23
13