Publicité
Les langues disponibles
Les langues disponibles
_______________________________________________________________________________________________________________________________
Please note: that the Aduro 16 must be installed on a floor with the adequate load-bearing capacity. If the existing
construction does not meet this requirement, appropriate adaptation measures must be taken (e.g. a load-
distributing plate).
If the wood burning stove is to be placed close to flammable material, such as a wooden floor or carpet, it must be
placed on a non-flammable base (constructional hearth), which meet the building regulations and has minimum
dimension as shown in the illustrations above. The base (constructional hearth) should extend for at least 50 cm in
front of the wood burning stove, and 15 cm on each side.
2.2 Pipe connection
Aduro 16 leaves the factory with the flue outlet mounted on the top. If you require the flue outlet on the back,
remove the round circle from the rear cover at the upper rear of the stove and then exchange the exhaust
connector (located on the top outlet above the stove) with the cover plate (that covers the rear outlet). The top
outlet is finished with the plate that lies in the ash drawer. A flue pipe with an internal diameter of 150 mm should
be used for Aduro stoves.
Please note that it is possible to mount the stove with a five inches flue pipe.
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, the rear outlet should be used, or a curved flue pipe via the top
outlet. After measurement, a hole is made in the chimney in which the pipe sleeve is placed and fireplace mortar is
used to seal it in place. The stove is placed in position and the flue pipe is put in place. A thin gasket is placed
between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude 5–10 cm into the pipe
sleeve, but must not block the opening in the chimney (see the illustration below).
25
Publicité
