ADURO 9-7 Mode D'emploi page 31

_______________________________________________________________________________________________________________________________
circumstances, the wood burning stove should be working with this damper open between 60 % and 100 %. You
should never close the air intake so far that the flames are extinguished. There should always be visible flames in
order to achieve clean and efficient combustion. A too low supply of air can lead to bad combustion, high emissions
and a bad efficiency. The air-wash system, that minimizes soot collecting on the front glass pane, is also adjusted
by this damper.
If you wish to fire the stove with the lowest effect possible – around 3 kW – you must close the secondary damper
almost completely 45 minutes after the wood has been put in. At this point there are only few flames and the stove
can burn clean by using the tertiary air from behind in the stove.
3.6.1 Secondary damper side glass
The secondary damper over the side glass allows you to adjust the wood burning stove to the chimney draft and
the heat output you require. It also helps to keep the side glass clean when opened.
Aduro Key: provides easier control of the secondary damper. The key is fitted onto the control handle, so you can
more easily adjust the airflow from side to side. Turning to the left decreases the airflow, and turning to the right
increases the airflow.
3.7 Primary damper
When you add a new log, the primary air intake/damper should be opened until the fire is burning properly. In order
to utilize the fuel to the fullest extent, the embers should have burnt for so long that it is necessary to open the
primary air intake for approx. 2 minutes to get the new log to burn.
In order to reduce the risk of ash falling from the stove when the door is opened to add more fuel, it is a good idea
to open the primary air intake/damper for approx. 1 minute before the door is opened. This increases the draught
through the stove and reduces the risk that ash will drop on the floor.
Please note: if you overload the wood burning stove and burn more than approx. 3.1 kg wood/hour, there is a risk
that the lacquered surface of the stove will become discoloured and eventually fall off. The stove can be
resurfaced, but this is not covered by the manufacturer's guarantee. In the same way, any other damage to the
stove caused by overloading will not be covered by the guarantee.
3.8 Aduro-tronic
The patent-applied Aduro-tronic is designed to operate the stove for you. All you have
to do is put dry wood in the stove, and activate the control system - Aduro-tronic does
the rest, leaving you to enjoy the flames and the benefits of efficient combustion.
Aduro-tronic is a manually operated mechanical start-up device, which works without
the use of electricity.
Please note: Use of dry wood of the right size is important to achieve optimum
combustion.
31