Publicité
2. (Figure 12) Hold the assembled frame tubes so that
the center holes face down. Insert the upper frame
tubes down through the stitched flaps in the sides of
the hopper bag.
3. (Figure 13) Fasten a rear frame tube (center holes facing
up) to the two lower frame tubes using two plastic plugs
(Z).
REAR FRAME TUBE
(brace holes on top)
PLASTIC PLUG (Z)
LOWER
FRAME
SIDE TUBE
ENGLISH
4. (Figure 14) Place the assembled frame tubes into the
5. (Figure 14) Attach the ends of the lower frame tubes
12
UPPER FRAME
TUBE
13
6. (Figure 15) Insert the bag frame strap into the stitched
7. (Figure 15) Assemble the bag frame strap to the lower
8
bottom of the hopper bag.
to the inside of the upper frame tubes using two 3/8"
x 1/2" clevis pins (O) inserted from the inside, and two
3/32" hair cotter pins (N).
UPPER FRAME TUBE
LOWER FRAME TUBE
sleeve along the front edge of the bag bottom.
frame tubes using two 1/4" x 1-1/8" clevis pins (P) and
3/32" hair cotter pins (N).
BAG FRAME STRAP
1/4" x 1-1/8"
CLEVIS PIN (P)
14
3/32" HAIR
COTTER PIN (N)
3/8" x 1/2"
CLEVIS PIN (O)
HOPPER BAG
BOTTOM
15
3/32" HAIR
COTTER PIN (N)
Publicité
