Publicité
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(2)
7/16" Open End or Box End Wrenches
(2)
1/2" Open End or Box End Wrenches
All loose parts are shown on page 2. Fasteners in the parts
bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown on
pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined
from the operator's position while seated on the tractor.
1. (Figure 1) Each brush assembly has one brush retainer
marked with either red or black ink. Lay out the brush
assemblies as shown so that the brush retainers marked
with ink are in the middle with the red one on the right
and the black one on the left.
OVERLAP BRISTLES
BRUSH RETAINER
MARKED BLACK
ENGLISH
1
BRUSH RETAINER
MARKED RED
5
IMPORTANT: T he overlap bristles at the bottom of each brush
help support the back side of the brush for better sweeper
performance. Be sure the sweeper is turned as shown in
figures 2 and 3 to correctly assemble the brushes.
2. (Figure 2) Attach brush assembly with red brush retainer
to right end of brush shaft using two 1/4" x 1" hex bolts
(G) and 1/4" nylock nuts (I). The brush retainer marked
with red ink must be placed to the middle of the sweeper.
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED RED
3. (Figure 3) Attach brush assembly with black brush
retainer to left end of brush shaft using two 1/4" x 1"
hex bolts (G) and 1/4" nylock nuts (I). The brush retainer
marked with black ink must be placed to the middle of
the sweeper.
4. (Figure 3) Turn a wheel to rotate the brushes. (Wheels
drive brushes in one direction only.) The overlap bristles
should be on the back side of the brush as it rotates.
BRUSH RETAINER
MARKED BLACK
1/4" x 1"
HEX BOLT (G)
OVERLAP
BRISTLES
BRUSH RETAINER
MARKED RED
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
2
3
Publicité
