Weber PERFORMER DELUXE GBS 58400 Manuel De Montage page 23

PROBLEM
Burner burns with a yellow or orange flame, in
conjunction with the smell of gas.
Burner does not light, or flame is low.
Burner flame pattern is erratic.
Burner does not ignite when you push the igniter
button.
Timer does not work.
Inside of lid appears to be "peeling." (Resembles
paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
TROUBLESHOOTING
Inspect burner for possible obstructions.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does the burner light with a match?
Is the hose to burner tube connection properly
secured?
Is burner clean?
Be sure that there is gas flow to the burners by
attempting to match light your burners. Refer to
"MANUAL IGNITION."
Is there a fresh battery installed?
Are the wires connected properly to the ignition
module?
Is there plastic wrapping around the new battery?
Is there a fresh battery installed?
What you are seeing is baked-on grease that has
turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
.
®
CHECK CURE
Clean burner.
(See "Maintenance" section)
Replace LP cylinder.
Straighten fuel hose.
If you can light the burner with a match, then check
the ignition system.
Connect the gas hose to the burner tube using the
metal retaining clip provided.
DANGER: Do not use the gas ignition feature
if the retaining clip is missing. A missing
retaining clip can cause serious bodily injury
or death, and damage to property.
Contact Customer Service for a replacement retainer
clip.
Clean burner.
(See "Maintenance" section)
If match lighting is successful, the problem lies in the
ignition system. Refer to "ELECTRONIC IGNITION
SYSTEM OPERATION."
Verify that the battery is in good condition and
installed correctly. Refer to "ELECTRONIC IGNITER
INSPECTION."
Be sure that wires are correctly inserted into
terminals on ignition box. Refer to "ELECTRONIC
IGNITION SYSTEM OPERATION."
Remove plastic wrapping.
Verify that the battery is in good condition and
installed correctly. Refer to "TIMER OPERATION."
Clean thoroughly.
(See "Cleaning" section)
WWW.WEBER.COM
® 23