DeWalt DW077 Guide D'utilisation page 12

CAUTION: Always use a ceiling wire hanger or equivalent
material, in addition to the wall mount clamp, to help secure the
laser level while mounting it to a wall. Thread the wire through the
handle of the laser level. DO NOT thread the wire through the
protective metal cage. Additionally, screws may be used to fasten
the wall mount directly to the wall as a back up. Screw holes (Q)
are located in the wall mount next to the measuring scales.
4. The tool can be adjusted up and down to the desired offset
height for working. To change the height, loosen the Rack 'N
Pinion locking knob (R) located on the left of the wall mount.
5. Turn the Rack 'N Pinion adjustment knob (S) located to the right
of the wall mount to move the laser level up and down to set
your height. Use the wall mount measuring scale to pinpoint
your mark.
R
S
NOTE: It may be helpful to turn the power on and turn the rotary
head so that it puts a dot on one of the laser scales. The D
target card is marked at 1-1/2" (38mm), therefore, it may be easiest
to set the offset of the laser to 1-1/2" (38mm) below the wall angle.
6. Once you have positioned the laser at the desired offset height,
tighten the Rack 'N Pinion locking knob to maintain the offset.
T
WALT
E
10
7. Using the base leveling knob (T) approximate a level position
from the wall.
Manual Head Rotation
The laser is designed with a protective alloy cage around the rotary
head to prevent accidental damage from work site activities. You
can still access the rotary head and manually direct the beam to
extablish or transfer a mark.
CAUTION: DO NOT attempt to manually rotate the head while
it is spinning. Manual head rotation should only be performed when
the laser is being used in dot mode (0 rpm).
Laser Accessories
Recommended accessories for use with your tool are available for
purchase at your factory-owned local service center.
CAUTION: The use of any non-recommended accessory may
be hazardous. Use only D WALT accessories designed for use
E
with this product.
If you need any assistance in locating any accessory, please
contact D WALT Industrial Tool Co., 701 East Joppa Road,
E
Baltimore, MD 21286 or call 1-800-4-D
See our catalog on the World Wide Web at www.DEWALT.com.
Laser Enhancement Glasses
The D WALT Laser Kit includes
E
a pair of Laser Enhancement
Glasses. These red lens glasses
improve the visibility of the laser
beam under bright light conditions or over long distances when the
laser is used for interior applications. These glasses are not
required to operate the laser.
CAUTION: These glasses are not ANSI approved safety glasses
and should not be worn while operating other tools. These glasses
do not keep the laser beam from entering your eyes.
WALT. (1-800-433-9258)
E