Tectro TD 101 Manuel D'utilisation page 38

Setting the hydrostat to the 'MAX.' position keeps the device in continuous operation.
4 Turn the adjustment button to the 'OFF' position to turn the device off.
WATER DRAINAGE
When the water container is full, the
off automatically. Empty the container and replace it in the correct position. The device
will restart.
If desired, it is possible to connect a drainage hose to the device for permanent water
drainage. Follow these steps:
1 Remove the water container from the dehumidifier.
2
Remove the removable, fixed, round cover on the back of the dehumidifier using a tool.
3 Put a flexible hose, internal diameter 13 mm., through the hole made at point 2.
4 Connect the drainage hose, via the front side of the dehumidifier, to the drain sprout
in the left upper corner of the area were normally the water container is placed.
5 Make sure that the loose end of the drainage hose is placed at a lower position than
the connecting point.
6 Place the end of the drainage hose in a water outlet.
7 Replace the water container.
When you no longer wish to use the permanent water drainage, disconnect the drainage
hose from the device. Ensure that the water container is positioned correctly.
CLEANING
Switch the dehumidifier off and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth. If the device is extremely dirty, use a mild cleaning
agent. Wipe the device with a slightly damp cloth. Never spray the device with water.
THE AIR FILTER
When used regularly, the filter may become clogged with dust and particles. Therefore the
filter should be cleaned every two weeks. Follow these steps:
1 Slide the filter out of the dehumidifier.
4
38
-light switches on and the dehumidifier switches