Milwaukee M18 Manuel De L'utilisateur page 38

Distribute 1 oz. of Type 'L' Grease
on top of Spiral Bevel Gear (36) and
at Gear/Connection Rod (59) interface.
TORQUE SPECIFICATIONS
Max.
Fig. Part No. (In-Lbs)
5 06-08-0015 190
9 06-81-0065 30
10 06-82-3830 35
11 06-82-3900 40
12 06-82-5316 35
13 06-82-5346 35
14 06-82-2620 15
15 06-82-7261 20
16 06-82-7290 20
Apply Type 'L' Grease, No. 49-08-4230 to
the inside of Needle Bearings (3,4) prior
to assembly.
Press Needle Bearing (4)
.030" minimum subflush.
Apply Green Loctite® 620
or equivalent to threads of
LH Drive Hub Bolt (5).
As an aid to install Extension Spring (44), assemble
gearcase components as shown. Loosen but do not
remove the three Orbit Slot Screws (10). This will allow
for the front end assembly, including the Barrel Cam (31)
to pivot away from the Left Gearcase (29). There should
be enough room to attach the Extension Spring to the
top recess area in the Barrel Cam and small hole in the
bottom front of the Left Gearcase. Spring should wrap
around the side of the Barrel Cam and rest inside
channel in the gearcase half. Retighten
the three Orbit Slot Screws.
Min.
(In-Lbs)
160
Orbit Slot
Screws (10)
25
25
30
25
25
10
10
10
Coat front bushing pocket area in both Gearcase Halves (29,30)
with a light film of Type 'B' Grease prior to assembly.
Apply Green Loctite® 620 or equivalent to
threads of Orbit Slot Screws (3 & 10) and
inside threads of Retaining
Plate (57).
Bearing seal direction
Apply Type 'L' Grease to all
rubbing surfaces in clutch:
Disc Spring (41) and
Metal Plates (51,52).
Extension Spring (44)
Distribute 3/4 oz. of Type 'B' Grease,
No. 49-08-2000 in the Left and Right
Gearcase halves (29,30), by Front
Bushing (58) around the Spindle (39).
Prior to assembly, saturate
the Felt Seal (60) with a
lightweight oil.
Left Gearcase
Assembly (29)
Barrel
Cam (31)