GE Profile PFDS450 Manuel D'utilisation Et D'installation page 48

Before you call for service...
PROBLEM
Clothes shrink
Greasy spots on clothes
Lint on clothes
Static occurs
Collars and waistbands
still wet at end of cycle
Slight variation
in metallic color
Door is too foggy to see
clothes during a steam
cycle
Water seen on inside of
door and top of lint filter
when opening door after
steam cycle
Small areas on clothes are Steam condenses on inner drum
damp after steam cycle
48
Possible Causes
Some fabrics will naturally shrink • To avoid shrinkage, follow garment care labels exactly.
when washed. Others can be
safely washed, but will shrink
in the dryer
Improper use of fabric softener
Drying dirty items
with clean ones
Clothes were not
completely clean
Lint filter is full
Improper sorting
Static electricity can attract lint
Overloading
Paper, tissue, etc., left in pockets • Empty all pockets before laundering clothes.
No fabric softener was used
Overdrying
Synthetics, permanent press
and blends can cause static
The dryness monitor senses
that the body of the clothes
is dry
This is normal
Steam condenses on inner door
Steam condenses on these
surfaces
Cycle or cycle time selected too
long for size of load
What To Do
• Some items may be pressed back into shape after drying.
• If you are concerned about shrinkage in a particular
item, do not machine wash or tumble dry it.
• Follow directions on fabric softener package.
• Use your dryer to dry only clean items. Dirty items can
stain clean items and the dryer.
• Sometimes stains which cannot be seen when the
clothes are wet appear after drying. Use proper washing
procedures before drying.
• Clean lint screen before each load.
• Sort lint producers (like chenille) from lint collectors
(like corduroy).
• See suggestions in this section under STATIC.
• Separate large loads into smaller ones.
• Try a fabric softener.
• Bounce Fabric Conditioner Dryer Sheets have been
®
approved for use in all GE Dryers when used in
accordance with the manufacturer's instructions.
• Try a fabric softener.
• Adjust setting to LESS DRy or DAMP.
• Try a fabric softener.
• Choose SPEED DRy or TIMED DRy to dry damp collars
and waistbands. In the future, when drying a load with
collars and waistbands, choose MORE DRy.
• Due to the metallic properties of paint used for this unique
product, slight variations of color may occur due to
viewing angles and lighting conditions.
• This is normal.
• This is normal.
• Select a shorter cycle.
• Manually reduce cycle time for given cycle.