GE Profile PFDS450 Manuel D'utilisation Et D'installation page 10

About cycle options.
NOTE: Not all features are available on all dryer models.
L
OCK
Push to Lock Control
Hold 3 Secs to Unlock
D
RUM
L
IGHT
S
ETTINGS
Press & hold for 3
seconds for secondary
options
About dryer features.
10
Lock
You can lock the controls to prevent any selections
from being made. Or you can lock the controls
after you have started a cycle.
children cannot accidentally start the dryer
by touching pads with this option selected.
Settings
Under the SETTINGS option, you can
adjust the volume or the brightness of
the display.
VOLUME
n End of Cycle (signal) volume can be set from
HIGH, MED, LOW or OFF.
n Control Sounds volume can be set from
HIGH, MED, LOW or OFF.
Drum Lamp
Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at
the household distribution panel by removing the fuse or switching off the circuit breaker. Reach
above dryer opening from inside the drum. Remove the bulb and replace with the same size bulb.
To lock the dryer, press the LOCK button.
To unlock the dryer, press and hold the LOCK
button for 3 seconds.
The light in center of the LOCK button will light up
when the controls are locked.
Even though the controls are locked, the POWER
button is still active in case you have to turn the
unit off.
DISPLAy BRIGHTNESS can be set from HIGH,
MED or LOW.
After you have made your selection,
press ENTER.
NOTE: To access the SETTINGS menu, hold
down the DRUM LIGHT button for 3 seconds.