GE Profile PFDS450 Manuel D'utilisation Et D'installation page 38

REVERSING THE DOOR SWING (if desired)
REVERSE HINGE AND CAPS (CONT.)
• Assemble the hinge to the opposite side
of the inner door, using 4 screws (#8-32 x 0.50"
machine screws).
• Assemble the new inner door cap (from
reversibility kit) on the opposite side of the hinge,
using 2 screws (#8 x 0.75" tapping screws).
• Install the the screws, nuts and washers on the
opposite side of the hinge in the 2 remaining
holes.
Replace
2 x D
Replace
screws
2 screws,
2 nuts and
Inner
2 washers
door cap
• Flip the inner door so that the inner part faces
down. Assemble the inner cover (mask), be sure
the snaps have clamped the inner cover.
Assemble the outer window, be sure the 2 snaps
have clamped the outer window.
Outer window
Inner cover
(Mask)
Installation Instructions
Hinge
Replace
4 x E
screws
Snap
Snap
38
REASSEMBLE DOOR ASSEMBLY
5
Turn the inner door
over and place on
a soft, protected
flat surface so that
the inner part is facing
down. Assemble
the chrome cover
to the inner door by
placing them together.
Flip the door assembly over and assemble, using
7 screws (#10 x 1.125" tapping screws).
7 x A Screws
REVERSE FRONT PANEL PLUG
6
BUTTONS AND STRIKE PLATE
Remove the 2 plug buttons on the dryer front
panel, using a putty knife or other flat tool as
shown, and reinstall on the opposite side. Switch
the strike bracket and its cover by removing
2 screws (#8 x 0.625" tapping screws) for each
and reinstalling on opposite sides.
2 Plug
buttons
Strike
bracket
NOTE: Apply a protective piece of tape to the side
of the plug button where the putty knife blade will
be inserted to prevent scratching.
Protective
piece of tape