Description - Hilti PM 2-P Mode D'emploi

Symbols
Disposal of
power tools
or
en
appliances
and batteries
together with
household
waste is not
permissible.
On the tool
C A U T I O N
LASER RADIATION - DO NOT
STARE INTO BEAM
620-690nm/0.95mW max.
CLASS II LASER PRODUCT
Do not stare into the beam.

2 Description

2.1 Use of the product as directed
The PM 2-P is a self-leveling point laser which allows a single person to carry out vertical alignment work quickly and
accurately. The tool features two coincident laser beams (beams that originate from the same point). All beams have
the same range of 30 m (range depends on the brightness of ambient light).
The tool is designed to be used to mark plumb points, mainly in interiors.
When used for outdoor applications, care must be taken to ensure that the general conditions are similar to those
encountered indoors. Possible applications are:
Transferring measuring marks from the floor to the ceiling.
Modification of the tool is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
2.2 Features
The PM 2-P levels itself automatically within a range of approx. 4°.
Self-leveling takes only approx. 3 seconds.
When the self-leveling range is exceeded, the laser beam blinks to warn the user.
The PM 2-P is characterized by its ease of operation and use, its rugged plastic casing and ease of transport due to
its compact dimensions and light weight.
When in normal operating mode, the tool switches itself off after 15 minutes. Sustained operating mode is possible by
switching on, switching off and switching on again within 3 seconds.
2.3 Information displayed during operation
LED
10
Laser warning plates for the USA in accordance with CFR
21 § 1040 (FDA).
On the tool
Laser radiation. Do not look into the beam. Laser class 2.
Laser
1/EN 60825‑1:2007
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
The LED doesn't light.
The LED doesn't light.
The LED doesn't light.
The LED lights constantly.
warning plates based
The tool is switched off.
The batteries are exhausted.
The batteries are inserted incorrectly.
The laser beam is switched on. The tool
is in operation.
on IEC 60825-