Description - Hilti PMP42 Mode D'emploi

Symbols
Read the Disposal of
operating power tools
instructions
en
before use. appliances
and batteries
together with
household
waste is not
permissible.
Laser class 2
according to
EN 60825-
1:2007

2 Description

2.1 Use of the product as directed
The PMP 42 is a self-leveling plumb laser which allows a single person to carry out vertical alignment work quickly
and accurately. The tool features two coincident laser beams (beams that originate from the same point). All beams
have the same range of 30m (range depends on the brightness of ambient light).
The tool is designed to be used to mark plumb points, mainly in interiors.
When used for outdoor applications, care must be taken to ensure that the general conditions are similar to those
encountered indoors.
Modification of the tool is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
2.2 Features
High laser beam accuracy (±3 mm at 10 m).
Self-levelling to within ±5° in all directions.
Short self-levelling time: ~3 seconds.
When the self-leveling range is exceeded, the laser beam blinks to warn the user.
The PMP 42 is characterized by its ease of operation and use, its rugged plastic casing and ease of transport due to
its compact dimensions and light weight.
When in normal operating mode, the tool switches itself off after 15 minutes. Sustained operating mode can be
selected by pressing the on/off button for four seconds.
2.3 Information displayed during operation
LED
10
Laser class II
according to
or CFR 21, § 1040
(FDA)
The LED doesn't light.
The LED doesn't light.
The LED doesn't light.
The LED lights constantly.
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
The tool is switched off.
The batteries are exhausted.
The batteries are inserted incorrectly.
The laser beam is switched on. The tool
is in operation.