Publicité
Les langues disponibles
Les langues disponibles
Anleitung_4133000_SPK1:_
GB
5. Technical data
Working pressure in bar
Tank volume in l
Weight in kg
6. Quick-release coupling
Connect
Push the nipple on your compressed air hose into
the quick-release coupling, the sleeve will automati-
cally spring forwards.
Disconnect
Pull back the sleeve and remove the hose.
Important. As you release the hose coupling,
hold the hose coupling part in your hand to pre-
vent injuries caused by the hose being thrown
backwards.
The compressed air hose is also fitted with a quick-
lock coupling to which accessories can be connected
as described above.
7. Operation
Unscrew the tank cover, fill it with lacquer or paint
and reseal it. Connect the compressed air supply.
Set the air pressure on the compressor's pressure
reducer. A filter pressure reducer must be used for
coating lacquer so as to remove oil and water
residue from the compressed air.
Adjust the rotary nozzle (2) to suit the direction of
movement during coating. The required distribution
and application volume can be set using the point /
wide cone regulator (3) and the volume regulator (4).
The infinitely variable trigger lever (5) allows an exact
dosing of the spray material. The further you press
the trigger lever (5), the more material will be added
to the compressed air. The maximum volume of coat-
ing material can be limited using the volume regula-
tor (4).
Tip: Before starting work you should conduct a brief
test on newspaper to find the perfect settings. The
best results can be achieved if you apply the material
in several coatings, applying it using alternate hori-
zontal and vertical movements. Maintain a constant
distance from the workpiece to ensure uniform
6
30.08.2010
13:06 Uhr
Seite 6
results and also press the trigger lever whilst swing-
ing the unit right up to and beyond the edge of the
workpiece to prevent visible bare patches.
3-4
0.6
8. Cleaning and maintenance
0.5
8.1 Cleaning
We recommend that you clean the appliance
immediately after you use it.
Clean the accessories after use with a suitable
cleaning agent (observe the instructions on the
working materials).
8.2 Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
9. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
Publicité
