Hama Professional M8CD Mode D'emploi page 10

g
4.2.2 Shred paper and plastic cards in the paper feed
shaft
■ Insert the paper or the plastic card into the centre of the feed shaft
(8). The cutting rollers are switched on automatically.
■ Let go of the paper or plastic card. The device switches back to
standby mode after shredding is completed.
NOTE!
►
4.2.3 Shredding CDs, DVDs, and BluRay discs and
plastic cards
■ Slide the operating switch (4) to the "Rev/On CD" position. The
cutting rollers begin turning continuously and the device is ready
for shredding CDs, DVDs, Blu-ray discs and plastic cards.
■ Insert the CD, DVD, Blu-ray disc or plastic card into the centre of
the feed shaft (6).
■ Let go of the CD, DVD, Blu-ray disc or plastic card. After shredding
is complete, slide the operating switch (4) to the "OFF" position in
order to switch the device off, or slide it to "On/Auto" to switch to
standby mode for paper and plastic card shredding.
4.2.4 Reverse run mode
NOTE!
►
■ Slide the operating switch (4) to the "Rev/On CD" position. The
rollers of the paper cutting system rotate in the opposite direction.
■ Slide the operating switch (4) to the "On/Auto" position.
■ Switch approximately three times successively between the posi-
tions "Rev/On CD" and "On/Auto".
■ Switch off the device and remove the jammed paper or plastic card
from the feed shaft (8).
10
Empty the bin frequently in order to prevent damage to the
device.
These modes serve to remove any blockages in the cutter
system.
Professional M8CD