"AT52" AMPLIFIED INDOOR ANTENNA
The Meliconi AT 49 amplified indoor antenna receives and amplifies digital terrestrial TV
signals and DAB radio signals in the VHF (band III, 174 - 240 MHz) and UHF (470 - 790
MHz) bands.
The antenna may be connected to a television set or a Digital terrestrial decoder.
• Product for indoor use only; do not use outdoors.
• Keep away from water: the device must not be exposed to drips or sprays of water. Do not
use in a damp environment.
• The product must not be exposed to excessive heat, like direct sunlight, fire or similar heat
sources.
• Do not connect the device to any power supply other than the one it was supplied with.
• The power supply unit must be easily accessible to enable the separation of the device from
the electrical mains supply.
• In the event of a fault with the power supply, disconnect it from the electrical mains socket
immediately.
• Do not tamper with, or attempt to repair the device – danger of electric shock.
• The product is not a toy. Keep out of reach of children or domestic animals.
• Disconnect the devices from the electrical mains supply before connecting them together.
A
• Place the antenna in a favourable position, for example, near a window and/or pointing
in the direction of the television transmitter, and at a safe distance from metal objects,
electrical equipment and reinforced concrete walls that could limit reception.
• Using the cable supplied, connect the antenna to the socket on the rear of the television
set or digital terrestrial decoder. If the decoder is fitted with an F-female type antenna
socket, use an F-male plug to IEC-female socket adapter (not included).
• The antenna uses an AC/DC power supply unit (supplied); insert the cable into the
antenna power supply socket and connect the power supply unit to a 230 Vac/50 Hz
mains power socket.
• When using the antenna on a boat or in a camper van, it may be supplied via the DC
12 V 100 mA input socket, taking care to respect the polarity indications marked on the
power supply socket. (adapter not supplied)
• Rotate the know A to switch the antenna on and set the amplification to the maximum.
• Check that the LED on the antenna is illuminated, indicating that the power supply is
correct.
• Switch the device /TV/DECODER) on and select the desired channel.
• Alternatively, in the case of certain decoders or TV sets, the power supply can be
supplied directly via the antenna cable (see the TV/DECODER manual).
AT49
INSTRUCTIONS FOR USE
Thank you for choosing MELICONI.
SAFETY WARNINGS
Installation
(refer to page 2 for connection information)
GB
5