MELICONI AT55 Black Mode D'emploi page 5

"AT52" AMPLIFIED INDOOR ANTENNA
The Meliconi AT 55 amplified indoor antenna receives and amplifies digital terrestrial TV signals
and DAB radio signals in the VHF (band III, 174 - 240 MHz) and UHF (470 - 790 MHz) bands.
• Product for indoor use only; do not use outdoors.
• Keep away from water: the device must not be exposed to drips or sprays of water. Do not
use in a damp environment.
• The product must not be exposed to excessive heat, like direct sunlight, fire or similar heat
sources.
• Do not connect the device to any power supply other than the one it was supplied with.
• The power supply unit must be easily accessible to enable the separation of the device from
the electrical mains supply.
• In the event of a fault with the power supply, disconnect it from the electrical mains socket
immediately.
• Do not tamper with, or attempt to repair the device – danger of electric shock.
• The product is not a toy. Keep out of reach of children or domestic animals.
• Disconnect the devices from the electrical mains supply before connecting them together.
A
• Place the antenna in a favourable position, for example, near a window and/or pointing in
the direction of the television transmitter, and at a safe distance from metal objects, electrical
equipment and reinforced concrete walls that could limit reception.
• Using the cable supplied, connect the antenna to the socket on the rear of the television set
or digital terrestrial decoder. If the decoder is fitted with an F-female type antenna socket, use
an F-male plug to IEC-female socket adapter (not included).
• The antenna uses an AC/DC power supply unit (supplied); insert the cable into the antenna
power supply socket and connect the power supply unit to a 230 Vac/50 Hz mains power
socket.
• Press button A on the power supply plug to switch the antenna on, and rotate the knob B on
the rear of the antenna counter-clockwise to set it to maximum amplification.
• Check that the LED on the antenna is illuminated, indicating that the power supply is correct.
• Switch the device /TV/DECODER) on and select the desired channel.
• Alternatively, in the case of certain decoders or TV sets, the power supply can be supplied
directly via the antenna cable (see the TV/DECODER manual).
AT55 Black
INSTRUCTIONS FOR USE
Thank you for choosing MELICONI.
SAFETY WARNINGS
Installation
(refer to page 2 for connection information)
GB
5