Domo DO1001SV Mode D'emploi page 42

3. Return the HEPA filter to the course dirt filter.
4. Return both filters to the dust container. Ensure that the notch in the filter is lined up with
the raised part of the container.
5. Return the dust container to the motor compartment by rotating it anti-clockwise. Make
sure that the mark on the motor unit is aligned with the lock symbol.
THE FILTERS IN THE MOTOR COMPARTMENT
There are two filters in the motor section.
1. Use the release button at the top of the motor compartment to open it and raise the
cover.
2. Remove the two dust filters. Blow compressed air through the filters to clean them. You
can also wash the filters under running water. Take care to dry them completely before
using them again in the appliance.
3. Return the filters to the motor compartment. Ensure that the black filter is at the top.
Return the cover to the motor compartment. To do this, first hook the cover onto the
front of the motor compartment and then click the cover into place.
CLEANING THE FLOOR BRUSH
1. Remove the floor nozzle from the upright vacuum cleaner. Press the
the back of the floor nozzle and remove it from the machine.
2. Use a screwdriver to undo the lock on the bottom of the floor brush. You can then lift the
lock upwards.
42
DO1001SV
release button at