Sony DRC-BT30 Mode D'emploi page 11


Perform pairing procedure on
the Bluetooth device to detect
this unit.
The list of detected devices appears
on the display of the Bluetooth
device. This unit is displayed as
"DRC-BT30." If "DRC-BT30" is
not displayed, repeat from step 1.
Notes
 For details, refer to the operating
instructions supplied with the
Bluetooth device.
 When pairing with a Bluetooth device
that cannot display a list of detected
devices or that has no display, you
may pair the device by setting both
this unit and the Bluetooth device to
pairing mode. At this time, if passcode
is set besides "0000" on the Bluetooth
device, pairing cannot be done with
this unit.
4
Select "DRC-BT0" on the
display of the Bluetooth device.
5
If Passcode* input is required
on the display of a Bluetooth
device, input "0000."
Pairing is complete when the
indicator (blue) flashes slowly. The
message standing for "Pairing
complete" appears on the display
of some Bluetooth devices.
* Passcode may be called "Passkey,"
"PIN code," "PIN number," or
"Password."
Note
Passcode may not be required
depending on the connected Bluetooth
device. For details, refer to the operating
instructions supplied with the Bluetooth
device.
6
Start the Bluetooth connection
from the Bluetooth device.
This unit memorizes the device as
the last connected device. Some
Bluetooth devices may connect
with the unit automatically when
pairing is complete.
Tips
 To pair with other Bluetooth devices,
repeat steps 1 to 5 for each device.
 To delete all pairing information, see
"Initializing the unit" (page 25).
11
US