EIBENSTOCK EBS 125.4 O Notice Originale page 19

Let the machine run for a short period of time and in a safe position. If the
machine does not run easily, stop working immediately.
Use only original accessory!
Application of Grinding Wheels
Type
Diamond Grinding Wheel
Concrete
Screed
Rapid K
Dust Extraction
Dust which occurs during your work is hazardous to health. That is why the
EBS 125.4 O/RO must be used with a vacuum cleaner, and a dust mask
has to be worn. The suitable Wet/Dry Vacuum Cleaner DSS 25 A / DSS 50
A / DSS 35 MiP is available as accessory. It can directly be attached to the
connection on the dust hood.
Changing the brush rim
If the length of the brushes is – due to wear - smaller than 5 mm (extreme
formation of dust during grinding), the brush rim has to be replaced
completely.
Now you can hold up the driving disc
between gearbox and grinding wheel by
using a jaw wrench 32 (1). Use the face
spanner (2) to unscrew the driving nut.
Then remove the mounted grinding
wheel respectively mount the new one.
The assembly works the other way
round!
Max. Colour
Rated Speed
10,000 rpm gold,
sand
10,000 rpm yellow
10,000 rpm blue
19
Application
for finishing and facing
concrete, brick, lime sand-
stone, basalt, sandstone
for finishing fresh and
green concrete, screed,
lime mortar plaster,
mortar, plaster, soft
limestone
for removing epoxy resin
and
two-component coatings