EIBENSTOCK EBS 125.4 O Notice Originale page 18

Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and release it again
Attention!
In case of every stop of the machine or a power cut, the
!
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
-
+
A permanent use with reduced speed can cause an overload because the
motor then gets less cooling air and therefore the machine will be
overheated much faster. A thermal switch-off can be released!
Changing the Diamond Grinding Wheel
Attention!
The grinding wheel might heat up enormously during operation. You
could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
First of all, the detachable hood
segment has to be opened.
The EBS 125.4 RO is equipped with an adjusting
wheel in order to allow a stepless variable control of
speed from 6000 to 10000 rpm. The adjusting wheel
is on the top side of the handle opposite of the
on/off switch.
18