Genie 180X Mode D'emploi page 10

1. Disconnect the main plug from the AC socket in order to avoid the risk of serious
injuries and wait at least 60 minutes until the overload guard has reset. Now tear
off excess paper from the top of the shredder or remove it.
2. Reconnect the main plug to the AC socket and press the REVERSE button. Pull
the remaining paper away from the shredding blades. If necessary, repeat this
step.
3. With pressing the FORWARD button and the open feed slot, you may now
continue the normal shredding process.
Technical data:
Shredding type:
Size of cut:
Shredding capacity:
Feed width:
Input voltage:
Dimensions:
Waste basket:
Noise level:
Cleaning:
Danger! Unplug the power cord before cleaning. There is a risk of electric
shock!
Warning! The blades of the device are very sharp! Danger of injury!
1. Empty the drip trays regularly.
2. Clean the drip trays and paper cutter with a slightly dampened cloth and possibly
with a mild detergent.
3. Remove any residue in the cutting holes with a suitable object. Make sure that
while cleaning the plug is pulled in order to avoid injuries.
Cross-cut
5 x45 mm (paper)
8 pages DIN A4 (80g)
approx. 220 mm
220~240 VAC, 50 Hz, 1,0 A
approx. 300 x 142 x 363 mm
ca. 13 l capacity
approx. 72 dB
- 10 -