CLOCK
(fig. 5.1)
1. Fig. 5.1 - Upon immediate connection
of the oven or after a power cut (black
out), the numbers on the programmer
display will flash.
2. Fig. 5.1 - To set the time, press button
for about one second; one hand
appears on 12.
3. Fig. 5.1 - Within 7 seconds press
or
buttons to set the time of the
day (hours and minutes). Seven sec-
onds after the last selection, the sec-
onds hand appears on the display.
Note: If the clock is reset it deletes
any previously set program.
1
2
3
Fig. 5.1
222
2 seconds
or
SHOWROOM MODE
When Showroom function is active, it
is not possible to use the oven (the
oven does not work).
This function can be only activated
/deactivated in time of day mode.
Press the button
and then the button
three buttons pressed until the buzzer
sounds (after about five seconds).
Three short beeps indicate the
Showroom activation while one short
beep indicates the deactivation.
If Showroom mode is active, this will be
indicated in time of day mode by the
fast blinking of number "6" in the display
(each 10 seconds).
The current mode will be kept after
power on and reset.
1
5 seconds
2
Fig. 5.2
(Fig. 5.2)
then the button
; keep these