M-system MFT 96 Mode D'emploi page 230

BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if
cleaned with products used for silver-
ware.
After cleaning or wash, check that burn-
er-caps and burner-heads are dry
before placing them in the respective
housings.
Note: To avoid damage to the electric
ignition do not use it when the burn-
ers are not in place.
C
F
Fig. 6.1
230
T
S
CORRECT REPLACEMENT OF THE
BURNERS
It is very important to check that the
burner flame distributor F and the cap C
has been correctly positioned (see figs.
6.1-6.2) - failure to do so can cause
serious problems.
Check that the electrode "S" (figs. 6.1 -
6.3) is always clean to ensure trouble-
free sparking.
Check that the probe "T" (figs. 6.1 - 6.3)
next to each burner is always clean to
ensure correct operation of the safety
valves.
Both the probe and ignition plug must
be very carefully cleaned.
Fig. 6.2