Ecoflam BLU 1500.1 LN PRE TC Mode D'emploi page 6

EN
Contents
- Index - General warnings
Overview
Contents
Function
Installation
Start up
Service
Overview
Contents
Important notes
BLU burners are designed
for the low-pollutant combustion of natural
gas and Liquefied Petroleum Gas.
The burners comply with standard EN676.
Assembly and commissioning must be
carried out only by authorised specialists
and all applicable guidelines and directives
must be observed.
Burner description
BLU PR are progressive, fully automatic,
monoblock type burners.
Burner head is designed to get the lowest
emissions in terms of NOx and unburnt
particles in order to maximize the heat
generator efficiency. Emissions can be
different respect to the ones recorded in
the lab because they depends a lot on the
generator on which the burner is fit.
The installer must comply with compulsory
rules. Avoid for instance dangerous
atmosphere or not ventilated rooms.
Ecoflam burners have been designed and built in compliance with all current regulations
and directives.
All burners comply to the safety and energy saving operation regulations within the standard
of their respective performance range. The quality is guaranteed by a quality and management
system certified in accordance with ISO 9001:2008.
6 www.ecoflam-burners.com
Technical data
Working fields
Dimensions
Index
General warnings
Burner description
General safety functions
Control and safety unit LAMTEC
Burner assembly
Electrical connection
Checks before commissioning
Adjusting burner output
Air pressure switch adjustment - setting gas pressostat
Maintenance
Troubleshooting
Gas pressure loss diagrams
Electrical diagrams
Spare parts list
Conformity declaration
We can accept no warranty liability
whatsoever for loss, damage or injury
caused by any of the following:
- Inappropriate use.
- Incorrect assembly or repair by the
customer or any third party, including the
fitting of non-original parts.
Provision of the system and the
operating instructions
The firing system manufacturer must
supply the operator of the system with
operating and maintenance instructions on
or before final delivery. These instructions
should be displayed in a prominent
location at the point of installation of the
heat generator, and should include the
address and telephone number of the
nearest customer service centre.
Notes for the operator
The system should be inspected by a
specialist at least once a year. It is
advisable to take out a maintenance
contract to guarantee regular servicing.
3
4
5
6
6
7
8
9
10
11
11
12
13
14
15
66-68
69-70
71-72
73
420010721500