Publicité
- en -
Dear customer
Thank you very much for choosing a weka product.
Read these instructions through completely before assembling your product in order to avoid errors in assembly or
damage.
IMPORTANT
Please use the enclosed packing list to check immediately that your weka product has been delivered
complete and intact.
Please do not dispose of the packing list before the guarantee period has expired. This list enables you to check that
all the individual parts are present. It should be retained along with the proof of purchase. Any complaints which may
arise can probably be easily rectified with this list. The item numbers on the packing list do not correspond to the
item numbers in the following assembly instructions.
We recommend that 3 people carry out the assembly.
In order to prevent accidents, we recommend that children are kept out of the direct vicinity during assembly.
We reserve the right to make further technological developments. This means that there many be minor deviations
in the illustrations.
Please do not simply throw away the packaging material. Paper, card and corrugated board as well as plastic
packaging materials should be placed in the correct collection containers.
RECOMMENDATIONS
Please drill pilot holes for all screw connections to avoid damaging the wood. The following symbol in the
instructions will indicate when this is necessary:
Protect the wood from hours of direct sunlight and moisture.
Wood is a natural product. Fluctuations in colour, knots and cracks are normal and have no influence on the statics.
A prerequisite for successful assembly, is the anchoring of the studs in the concrete foundation using H stud
supports. The stud supports are available as weka accessories for an additional cost.
NOTE!
The dimensions are to be checked regularly during the course of the entire installation!
A foundation plan can be obtained from your specialist dealer!
In order to facilitate the precise alignment of the H anchors, mark the necessary post clearances on a piece of guide
wood and fix the anchors in place with screw clamps
Then suspend the H anchors in the base holes already prepared. A minimum clearance of 2 cm is to be maintained
between the upper edge of the foundation and the upper strut.
After the holes have been filled with C25/30 concrete, the foundation must be allowed to set for at least 3 days.
Warranty terms of weka Holzbau GmbH
We guarantee the function of our products for 5 years from the date of delivery based on the following conditions –
however only on the wooden parts of our products (hereinafter weka product) and not on connected components or parts
of the weka product made of another material besides wood. Within the warranty period defective parts or missing parts
of the product or the product itself will be replaced at our discretion. The warranty extends only to the free-of-charge
replacement of the respective faulty or defective wooden part. The warranty does not cover any consequential or
additional costs, in particular no delivery and installation or modification costs.
The warranty is void in case of:
failure to follow the assembly instructions,
-
-
changes (additions or modifications) made to the product diverging from the assembly instructions,
-
load limits (e.g. snow load, etc.) having been exceeded,
-
the weka product having been installed on an incorrect foundation or floor plate, etc., in particular in case of
violation of the rules of architecture,
-
lack of or insufficient care of the wood (maintenance measures such as preservation or painting of the wood),
-
wind speeds stronger than force 7 (moderate gales), natural catastrophes or brute force having caused the
damage to the weka product,
-
the deficiency consisting in changes which are typical for wood, such as discoloration, formation of cracks,
warping, shrinking, swelling or similar normal effects on the material "wood".
Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
Copyright HRB 3662
4
Publicité
