Zanussi ZGG75524 Notice D'utilisation page 23

Problem
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
A
MOD.
PROD.NO.
SER.NO
DATA
A. Stick it on Guarantee Card and send this
part (if applicable).
B. Stick it on Guarantee Card and keep this
part (if applicable).
www.zanussi.com
Possible cause
The fuse is released.
Burner cap and crown are placed
incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Place the burner cap and crown
correctly.
After lightning the flame, keep the
knob pushed for equal or less
than 10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Labels supplied with the accessories
bag
Stick the adhesive labels as indicated below:
C
MOD.
PROD.NO.
SER.NO.
0049
C. Stick it on instruction booklet.
Remedy
TYPE
IP20
23