UK
WF21 Dimensions:
155 mm
WF UNIQ21
155 mm
WF UNIQ21 WALL HUNG/COMPACT
Westfire Insulated chambers
The Westfire WF UNIQ21 wood burning stove is lined with heat deflection panels and baffles, these panels are
designed to ensure the maximum efficiency and are an integral part of the clean burn process of the stove.
These baffles should not be removed apart from for cleaning the stove. Any defective panels should be replaced.
Connection to chimney
Westfire WF UNIQ21 wood stoves have both rear and top flue connector that allows connection to either a
masonry chimney or a prefabricated factory made insulated metal chimney in accordance with the instructions for
"Connection to chimney" given in the instruction booklet.
Commissioning and handover
Ensure loose parts are fitted in accordance with the instructions, page 15 & 16. 'Vermiculite fire brick installation
sequence' before handover. Operation of primary and secondary air controls must be fully explained.
On completion of the installation allow a suitable period of time for any fire cement and mortar to dry out, when
a small fire may be lit and checked to ensure the smoke and fumes are taken from the stove up the chimney and
emitted safely to atmosphere. Do not run at full output for at least 24 hours.
On completion of the installation and commissioning ensure that the operating instructions for the stove are left
with the customer. Ensure to advise the customer on the correct use of the appliance with the fuels likely to be
used on the stove and warn them to use only the recommended fuels for the stove.
Advise the user what to do should smoke or fumes be emitted from the stove. The customer should be warned to
use a fireguard to BS 6539 in the presence of children, aged and/or infirm persons.
800 mm
693 mm
97 mm
WF UNIQ21 PEDESTAL
80 mm
730 mm
623 mm
80 mm
82 mm
WESTFIRE · WF21
155 mm
1140 mm
1033 mm
492 mm
180 mm
30 mm
17 mm
696 mm
190mm
WF21 WALL HUNG BRACKET
Top of bracket is 18mm below top of stove
10
35 mm
40 mm
208 mm
208 mm
208 mm
35 mm