Westfire WF Uniq 44 Notice D'installation Et D'utilisation page 13

Table des Matières

Publicité

UK
WESTFIRE · WF 44 · WF 45 · WF 46
Operational Position of air sliders during operation and in adverse conditions
You need to become familiar with your stove in order to be able to regulate the air controls (sliders) correctly, as
outside factors such as the quality and height of your chimney, the quality of your fuel and the external weather
conditions can alter the stoves operational settings and performance.
Very damp weather can affect the draw of the stove and therefor more secondary air may be needed to adjust.
Very still cold clear days induce more draught and the setting for secondary air may be less than nominal settings.
Such accommodations will become normal once you are familiar with your stove.
It is easy to see whether the stove is functioning correctly; incomplete combustion will be shown by
1. The inside of the fire chamber firebricks having a black dusty build up,
2. A build-up of hard shiny soot on the inside of the glass
3. Smoking chimney
To prevent sooting of the chamber and glass introduce more secondary air, also check that your wood is dry.
CONTROLS ON WESTFIRE UNIQ44/ UNIQ45/ UNIQ46
Door operation
When opening the door of your Westfire stove always wear the glove that is provided to protect your hand from
possible heat. The handle pulls out right away from the fire. When shutting the door push the door closed and push
the handle until the handle firmly closes.
WOOD FUEL
IMPORTANT: Never use toxic wood such as chipboard, impregnated or painted wood.
Good quality wood is the most important factor in your stove working efficiently and cleanly. Always use dry
firewood. The dryness of the firewood plays an important role since the use of wet wood results in poor fuel
economy and may cause a tarry sooty film on the internals of the stove.
Newly cut wood contains 60-70% water, making it totally unsuitable for use as firewood.
Newly cut wood should be stacked and air dried under cover for two years before being used as firewood.
SMOKELESS COAL, HOUSE COAL AND PETROLEUM COKE ARE NOT SUITABLE FOR USE ON THIS STOVE; ITS USE WILL
INVALIDATE THE GUARANTEE
SOLID SMOKELESS FUELS – WESTFIRE Uniq 44/ 45/ 46 models are NOT suitable for use with smokeless fuels and have
not been tested to the relevant European standard. Only use wood for these stoves.
PETROLEUM COKE IS NOT SUITABLE FOR USE ON THIS STOVE; ITS USE WILL INVALIDATE THE GUARANTEE
Overnight burning
Westfire stoves are wood stoves, wood burns more efficiently and cleanly if is burnt hotter. Westfire do not
recommend that their stoves are burnt overnight for this reason.
As a night time regime we recommend that the fire is loaded when hot and burnt for five minutes with the
secondary air valve fully open until the new wood has taken and is burning, then close the secondary air valve to
its operational position.
On returning to the stove in the morning the fire will have burn out, reload with some paper or firelighter and some
kindling and open all the values fully open and the stove will relight quickly. Beware as the ash bed will have hot
embers.
Use of operating tools
Always use the operating tools provided when handling parts likely to be hot when the stove is in use.
Maintenance
UNIQ44 / UNIQ45 / UNIQ46 wood stoves needs to have the ash removed from the stove
at regular intervals. Make sure the stove is completely cold before cleaning out ash (embers can remain hot for over
24 hours ). To clean the outside of the stove use a dry cloth.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wf uniq 45Wf uniq 46

Table des Matières