Shindaiwa T310Xs Manuel D'utilisation page 20

Before you start
1. L-wrench
Installing a blade
Do not attempt to fit the trimmer blade with one hand or without using the socket spanner. Fit the trimmer blade ac-
curately using the supplied socket spanner and tighten firmly in position.
The trimmer must not be used if the blade vibrates or is loose.
Wear heavy duty gloves when working with the trimmer blade. When replacing the trimmer blade during a trimming
task, ensure that the engine is switched off and that the blades have stopped.
Do not use any tools other than the proved socket spanner to tighten the blade, a pneumatic or electric tool may
tighten the blade more than necessary and cause the nut or the output shaft to break.
When turning the product over to replace the trimmer blade, ensure that the fuel tank cap is securely in place.
Failure to do so could lead to an injury or serious accident, or cause a fire.
1. Shaft bolt
2. Bolt guard
3. Holder B
WARNING
4. Output shaft
5. Holder A
6. L-wrench
4. Using the L-wrench to secure Holder A, install and hand-
tighten the trimmer head (counter-clockwise to install).
5. Remove the L-wrench from the gearcase and holder.
1. Turn the product upside down so the gearcase output shaft
is facing UP and remove the shaft bolt, bolt guard and holder
B from the gearcase shaft.
2. Align the hole in blade holder A with the matching hole in the
gearcase flange and then temporarily lock the output shaft
by inserting a L-wrench through both holes.
Install the blade so its printed surface is visible to the
operator when the brushcutter is in the normal operat-
ing position.
The blade must fit flat against the holder flange. The
blade mounting hole must be centered over the raised
boss on blade holder A.
18
CAUTION
WARNING