Shindaiwa T310Xs Manuel D'utilisation page 19

Cutting attachment shield assembly
1. Socket-head cap
Screw
2. Bracket
3. Shim
4. Clamp screw
5. Outer tube
1. Cutting attachment
shield
2. Hook receiver
Installing a trimmer head
1. Shaft bolt (not used)
2. Bolt guard (not used)
3. Holder B
6. Cutting attachment
shield
7. Shim
8. Cutting attachment
shield mounting plate
9. Retaining nut
3. Sub-shield
4. Hook
4. Holder A
5. Gearcase shaft
Before you start
Cutting Attachment Shield
1. Insert the cutting attachment shield between the outer tube
and the cutting attachment shield mounting plate.
NOTE
It may be necessary to loosen the retaining nut and clamp
screw to adjust cutting attachment shield mounting plate.
2. Fit the two shims and the bracket over the outer tube and
loosely install the four socket-head cap screws.
3. Tighten the four socket-head cap screws to secure the cut-
ting attachment shield.
Make sure the clamp screw and retaining nut are securely
tightened before tightening the four socket-head cap
screws.
Sub-shield (when trimmer head is in use) (Consult
your dealer.)
1. Attach the shield extension to the cutting attachment shield.
Never use this product without sub-shield when using a
trimmer head.
Make sure the sub-shield is completely hooked at the
hook receiver.
NOTE
This product is shipped with Holder A, Holder B, shaft bolt, and
bolt guard installed. The shaft bolt is a LEFT-HAND thread. Re-
move it by turning CLOCKWISE!.
1. With the gearcase output shaft facing up, rotate the output
shaft and Holder A until the hole in Holder A aligns with the
matching hole in the gearcase flange, and then lock the hold-
er to the gearcase by inserting the long end of the L- wrench
through both holes.
2. Using the socket wrench, remove the shaft bolt, bolt guard
and Holder B. (The bolt guard and shaft bolt are not used
with a trimmer head).
3. Install Holder B on the gearcase shaft. The splined hole on
Holder B must engage with the gearcase shaft.
17
CAUTION
WARNING
CAUTION