Charging With Solar Panels - Wagan Tech SOLAR e POWER CUBE 1500 Guide D'utilisation

Solar e Power
5. Turn ON the Battery Disconnect Switch
6. Periodically remove one DC plug and check the Digital LED Voltmeter to determine
when charging is complete (usually 13.5V is considered fully charged)
7. After charging the battery, disconnect the DC Charging Adapter from the vehicle acces-
sory socket first, then from the Solar e Power Cube DC Outlet.
8. Turn OFF the Battery Disconnect Switch if Solar e Power Cube is not in use.
9. Store the DC Charging Adapter in the Storage Hatch.
Do not leave the Solar e Power Cube connected to your vehicle's DC socket when the engine is
turned off.
CauTion—equiPmenT damage:
• While the Solar e Power Cube is being charged with the DC Charging Adapter from
your vehicle, do not operate the Inverter with a load of over 100 watts. Further, do not
plug in or operate any DC appliance from the Solar e Power Cube that requires more
than 10 amps. Either action may blow a vehicle fuse.
• Always remove the DC Charging Adapter from the vehicle's DC socket before starting
the vehicle.
• Disconnect the Solar e Power Cube from the vehicle's DC socket when the engine is
turned off to prevent discharging the vehicle's battery.
• Always remove the DC Charging Adapter from the vehicle's DC socket before starting
the vehicle.

Charging With Solar Panels

The Solar e Power Cube is supplied with five 16W solar panels (80 watts ). The top two panels
are hinged at the sides of the Solar e Power Cube and the lower two panels slide out from the
center of the Solar e Power Cube. The panels must be fully opened/extended to allow maximum
exposure to sunlight.
14
Cube 1500 by Wagan Tech®
™
www.wagan.com