ADURO Limestone 15SK Mode D'emploi page 34

3.2 Pipe connection
Aduro 15SK & 15SK Limestone leaves the factory with the flue outlet mounted on the top. If you require the
flue outlet on the back, remove the round circle from the rear cover at the upper rear of the stove and
exchange the exhaust connector (located on the top outlet above the stove) with the cover plate (that covers
the rear outlet).
If the pipe is connected to the back of the stove, place the 3 adjustable "holders" between the inner stove
and the underside of the stove in order to make sure that the small top plate can be placed correct and have
the same height as the soapstone/limestone top plate. The top outlet for Aduro 1.1 is finished with the top
plate that lies in the ashpan. A flue pipe with an internal diameter of 150 mm should be used for Aduro
stoves.
Please ensure that all local rules and regulations are complied with, including CE marking of the flue pipe.
Additionally, distance requirements to flammable material for the pipe must be respected.
3.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, the rear outlet or a curved flue pipe via the top outlet
should be used. After measuring, a hole is made in the chimney in which the pipe sleeve is placed and stove
mortar is used to seal it in place. The stove is placed in position and the flue pipe is put in place. A thin
gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude
into the pipe sleeve, but must not block the opening in the chimney (see the illustration below):
The stove can be connected to a chimney to which other heat sources are connected.
3.4 Safety wire
The stove comes with a safety wire. Please follow the mounting instructions below:
1. Mount the bracket on the wall central to the stove:
a. For Aduro 15: approx. 53 cm above the floor hearth.
b. For Aduro 15 Lux: approx. 53 cm above the floor hearth.
c. For Aduro 15.1: approx. 48.5 cm above the floor hearth.
d. For Aduro 15.2: approx. 53 cm above the floor hearth.
e. For Aduro 15.4: approx. 60 cm above the floor hearth.
f. For Aduro 15SK / 15SK Limestone: approx. 53 cm above the floor hearth.
g. For Aduro 18: approx. 69.4 cm above the floor hearth.
h. For Aduro 20: approx. 53 cm above the floor hearth.
2. Slide the safety wire through the two oblong holes in the backplate of the stove as well as through
the eye in the wall bracket. The safety wire ends must be secured in the rectangular wire lock
X
34