Plum FIXATION PIKA Mode D'emploi page 25

In the HIGH position, the heelpiece is turned in order to let the heel move
freely and to step on the high climbing wedge (12) of the binding.
In such a position, the toe piece must be set in WALK Mode.
To switch from one position to the next, follow this method:
- Elevate your boot so as not to be in contact with the heelpiece.
- By using your hand or your ski poles flip the high climbing wedge to
reach the right position.
SKI Position (descent)
In SKI Mode, the heelpiece is rotated in order to have the pins facing towards
the front of the ski. These pins are the ones into which the boot steps.
In such a position, the toe piece must be in SKI Mode.
HOW TO STEP IN WALK MODE?
Make sure the toe piece clamp (1) is open. If closed, push the locker (3) down,
until the toe clamp opens.
Make sure the heelpieces are in one of the two uphill positions.
Check nothing is present under the toe piece or the ski and clean any foreign
material from your boot sole.
Find out which out the four following methods suits you:
- Method 1: place the toe of your boot over toe piece, keeping the heel a little
bit elevated, pushing down until the two front pins (1) fasten into the boot tip
insert (16).
User Manual
11 | P a g e